MAINTENANCE AND CLEANING electrolux 9
EN
Before carrying out any maintenance
or cleaning isolate the cooker hood
from the mains supply.
Charcoal Filters
In the recirculation mode the charcoal
fi lters absorb smells and unwanted
odours.
Enabling the alarm signal
• In Recirculation version Hoods, the
Filter saturation alarm can be enabled
on installation or at a later date.
• Turn the Lights and the suction Motor
off.
• Disconnect the Hood using the Main
switch or the double-pole switch on
the mains power supply.
• Restore the connection by pressing
and holding T1.
• Release the button. All fi ve LEDs are
turned on
• Within 3 seconds press T1 until LEDs
T1 and T4 fl ash in confi rmation:
• LED fl ashes twice - Activated
charcoal fi lter saturation alarm
ENABLED
• LED fl ashes once - Activated
charcoal fi lter saturation alarm
DISABLED
The fi lter is not washable and cannot
be regenerated. It must be replaced
when led S1 fl ashes or at least every
4 months. The alarm signal will only
light up when the extractor motor is
switched on.
To Remove/Replace the
Charcoal Filters
• Remove the metal grease fi lters
• Remove the saturated activated
carbon fi lter by releasing the fi xing
hooks
• Fit the new fi lter by hooking it into its
seating
• Replace the metal grease fi lters.
This appliance can be a possible fi re
hazard if the grease and charcoal fi l-
ters are not cleaned and replaced as
recommended.
Alarm signal reset
• Switch off the lights and extractor
motor.
• Press button T3 for at least 3 seconds,
until the leds start to fl ash.
To Next Page
Loading...
