8
Operating Instructions
S t a t u s w i n d o w
1h - 24h Indicates number of
delay start hours for
selected cycle.
CL Flashes once the
program has been
entered and the
START pad is pressed.
It also fl ashes if the
door is opened during
a wash cycle. Close
the door to begin or
continue the wash cycle.
B l u e l i g h t i n d i c a t o r
When the BLUE LIGHT illuminates on the fl oor this
indicates that the wash cycle is complete.
E r ro r C o d e s
Displayed
Error Code*
Problem Solution
i10
A low fi ll has been detected.
Look for a pinched water supply line, or water shutoff is
not completely opened.
i20;
i40;
iF0
Clogged fi lters or a restricted
drain line has been detected.
Check and clean both fi lters and sump area and check
for a pinched or blocked drain hose. If the drain line is
attached to a disposer, check that the knockout plug
has been removed.
i30
A leak or overfl ow of water
has been detected in the
bottom pan.
Look for loose connections at the water inlet valve and
ensure the unit is properly leveled.
i50
A problem has been
detected with the drain or
wash motor.
Pressing the cancel button or turning power off at the
breaker for 5 min. should clear this error code and
the unit can be restarted.
If this does not resolve the problem, service
will need to be called.
i60
A problem has been
detected with the water
heating system.
iC0
A problem has been
detected with the electronic
control system.
*In all Error Code instances, if Pressing the cancel button or turning power off at the breaker for 5 min.
does not resolve the problem, contact the Electrolux Customer Care Center at 1-877-435-3287.
That STATUS window displays codes typically seen during normal operation or programming of the
dishwasher. The STATUS window indicates the following activity:
Loc Child Lock is activated.
Minutes The cycle duration or
the remaining time.
L1 - L4 Level of Rinse Aid
Dosage.
U s e r I n s t r u c t i o n C o d e
Instruction
Code
Displayed
Problem
Solution
CL This indicates the door has been
left open or not properly latched.
Ensuring the door is properly latched will clear
the display. This does not indicate a problem with
your dishwasher and service will not need to be
contacted.
To Next Page
Loading...
