24
Maintenance schedule
EACH USE – Empty dust cup after each use OR when debris reaches fill line
EACH USE – Check filter screen. Remove and wash screen if debris is visible.
RED INDICATOR LIGHT – Clean foam filter
6 MONTHS – Replace HEPA filter
Press down carrying handle
and pull out dust cup.
Hold over waste basket.
Pull up orange lever to release lid.
Bottom lid will release;
both chambers will empty.
Close bottom lid until it snaps.
Put dust cup back in place.
Filter screen is inside dust
cup. Pull gray lever to release.
If needed, wash screen with
soap and water. Dry thoroughly.
Replace screen. Turn clockwise
to fit tabs into grooves and lock.
Filter screen must be in place
to reinstall dust cup.
Pull up tab to release filter cover. Wash foam filter and frame. Air dry;
reposition in cover. Press firmly at top to snap frame back in place. Filter
cover will not close if foam filter and frame are not in installed correctly.
Remove dust cup and set aside.
Pull filter cover up and out.
Grasp tab and pull out filter.
Replace with new filter.
Turn power switch to off (O) position and unplug power cord before cleaning filters.
Do not operate vacuum cleaner without filters in place, as this could cause severe damage to vacuum.
To Next Page
Loading...
