6
BEFORE FIRST USE
WARNING!
Refer to the safety chapters.
Initial cleaning
• Remove all parts from the appliance.
• Clean the appliance before first use.
Refer to chapter “Care and cleaning”.
Setting the time
When you connect the appliance to the electrical supply or
after a power cut, the display shows 0:00.
You can set the time in a 24 hour clock system.
1. Press
twice.
2. To set the amount of hours press the setting pads.
3. Press
to confirm.
4. To set the amount of minutes press the setting pads.
5. Press
to confirm.
6. The display shows On. The clock is shown on the
display when the appliance is not used. If you do not
want the clock to be shown when the appliance is in
standby mode press + or - and set OFF.
7. Press
to confirm.
To Next Page
Loading...
