5.3 Water dispenser cleaning procedure
• Unblock the two stopping elements on
the sides of the tank as shown in the
pictures:
• take out the PUREADVANTAGE car-
tridge from the water filter unit
• press the stopping elements in the mid-
dle and move it up
• move the stopper into direction of the
central tank.
• Push up the tank along the direction of
the valve.
• Remove the cover and the internal tank
• Unscrew the valve in counter clockwise
(pay particular attention not to lose the
Valve Gasket because is necessary to a
correct functioning of the features).
• Clean the tank lid, the valve and the
gasket with a solution of warm water
and neutral soap. Rinse it and put it in-
side the door hole during the cleaning
of the other components (in order to
avoid cold air leakage from the fridge).
• Clean the tank and the internal tank
with a solution of warm water and neu-
tral soap and rinse them.
• After the tank components cleaning
take back the valve from the fridge door
and assembly the tank in the inverse or-
der (4;3;2;1) of disassembly (pay atten-
tion at the valve gasket positioning).
• Put the assembled tank on the door
along the valve direction.
• Block the stopping elements in the in-
verse order of unblock.
• Insert again the PUREADVANTAGE
cartridge in the internal tank.
ENGLISH 13
To Next Page
Loading...
Need help?
General
