42 electrolux cleaning and care
Putting the door glass back
1. From above insert the door glass at
an angle into the door profile at the
bottom edge of the door and lower
it.
2. Take hold of the door trim (B) at each
side, position it on the inside edge of
the door and plug the door trim(B)
into the upper edge of the door.
On the open side of the door trim (B)
there is a guide bar (C). This must be
pushed between the outer door
panel and the guide corner(D).
The clip seal (E) must be snapped in.
To Next Page
Loading...
