30
electrolux
installation
Installation
•
This appliance must be installed by a
qualified electrician/competent
person. Safety may be impaired if
installation is not carried out in
accordance with these instructions.
•
This appliance must be earthed.
•
Do not remove the screws from the
earth tab extending from the oven
mains terminal block.
•
Before connecting the appliance
make sure that the voltage of your
electricity supply is the same as that
indicated on the rating plate. This is
situated on the lower front frame of
the appliance and can be seen upon
opening the door. Alternatively the
rating plate may also be found on the
back or top of some models (where
applicable).
•
Do not alter the electrical circuitry of
this appliance.
Things to note
•
This appliance is designed to be fitted
in cabinets of the recommended
dimensions as shown.
700
720
80
360
560 min
•
If there is an existing housing unit it
must be removed.
•
The dimensions given provide
adequate air circulation around the unit
within the cabinet, ensuring
compliance with BS EN60-335.
•
The appliance must not be installed on
a wooden base board.
•
Enquiries regarding the installation of
the cooker point, if required, should be
made to your Regional Electricity
Company to ensure compliance with
their regulations.
To Next Page
Loading...
