EasyManua.ls Logo

Electrolux EPH09NLIW - Energy Saving and Humidity Considerations; INSTALLATION; Installation Notes and Site Selection

Electrolux EPH09NLIW
114 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16 www.electrolux.com
Anti-cold air function
In HEAT mode, the indoor fan will not
operate in order to prevent cold air from
blowing out if the indoor heat exchanger
does not reach a certain temperature in
one of the following situations:
t when the heating operation starts;
t when the defrosting operation is
t when heating at low temperature.
Gentle breeze
The indoor unit may blow gentle breeze
and the horizontal louvre rotates to a
certain position in one of the following
situations:
t In HEAT mode, the compressor does
not start operation after switching on
the unit.
t In HEAT mode, the temperature
reaches the set value and the
compressor has stopped operation
for 1 minute.
Opetaring temperature range
The operating temperature range for
cooling-only units is -15-(+48˚C). The
operating temperature range for heat-
pump units is -20-(+24)˚C.
Tip for energy saving
t Do not overcool or overheat. Setting
the temperature at a moderate level
helps energy saving.
t Cover windows with a blind or a
curtain. Blocking sunlight and air from
outdoor is favorable for cooling.
t Clean air
every two weeks.
Clogged air filters lead to inefficient
operation and energy waste.
Tip for relative humidity
t If the unit is operated in an area with
a relative humidity of more than 80%
for a long time, condensate may drip
from the indoor unit.
Installation notes
t Not following the instructions can
cause personal injury and/or property
damage.
t Not following the instructions can
cause the unit to fail.
t Let the unit be installed by an
authorised service centre.
t Let the unit be installed in compliance
with local and governmental
regulations.
t Let the unit be installed according to
the instructions from this manual.
t First contact an authorised service
centre before relocating an already
installed unit
t Disconnect power before working on
the unit.
t Let the mains cable be repaired by an
authorised service centre or qualified
technician for units with Y-attachment.
t The mains plug must remain
accessible after installation.
t Keep
distance between
the interconnection cable and the
Indoor side (°C) Outdoor side (°C)
Max. cooling 32 48
Min. cooling 21 -15
Max. heating 27 24
Min. heating 20 -20
INSTALLATION

Related product manuals