4
Electrolux 818 19 39--00/3
Before use
GB
Position and clean the cabinet as explained i n the
section "Installation".
Check that the drain hose at the rear of the cabinet
discharges into the drip tray.
Before inserting the power plug into the
outlet and switching on the cabinet for
the first time, leave it standing upright
for about 4 hours. Otherwise the
compressor may sustain damage. This
time will allow the oil sufficient time to
return to the compressor.
Using the fridge
GB
To start the fridge and set the
correct temperature
Turn the thermostat control t o the desired position.
MIN The l owest position of the thermostat control
results in the highest temperature inside the cabinet.
MAX The highest position of the thermostat control
results in the lowest temperature inside the cabinet.
H : Switched off.
Allow the cabinet to run for a period of 24 hours
whenever the temperature setting is changed. This
will allow the temperature to stabilise inside the
cabinet.
Temperature inside the fridge
A suitable temperature inside the fridge is approx.
+5°C. If the thermostat control is set to a too cold
temperature, food with a high water content may
start to freeze if it has been placed in the coldest
places in the fridge. The picture shows the coldest
and warmest places inside the fridge.
(+ warm, - cold)
Meat, fish and milk should be put in the coldest part
of the cabinet.
The temperature will be affecteed by:
· How often the door is opened
· How m uch food is stored
· Position of the appliance (See chapter
Installation)
Measuring the temperature
If the temperature is measured using a standard,
single thermometer, t his should be put in a glass of
water centrally placed inside the cabinet. This will
reflect the temperature inside the food products. Do
not place the thermometer hanging or lying directly
on the shelf.
+
+
+
+
--
--
--
--
+
+
+
+
To Next Page
Loading...
