Electrolux ERC500 - Page 15

15
Malfunction
Indicator light does not
go on.
Electric heating
plate is not warm.
The warm light
does not go on
when the cooking
process is nished.
Rice is not cooked
or cooking time is taking
too long.
Possible Causes
• Circuitofelectricricecookerisnot
connected to power supply.
• Cookingtimeisinsucient.
• Theinnerpotisnotproperlyin
contact with the heating elements
• Possibleforeignmatterbetween
the inner pot and heating element.
• Notenoughwaterisadded.
Solution
• Checkthattheswitch,plugand 
socket, fuse and leading wire of the
power supply are in good condition
and properly connected to the
mains and if plug is inserted rmly
into the wall socket.
• Addwateraccordingtothescale
on the inside of the inner pot.
• Pressdownthecontrolleverto
start the cooking process.
• Makesurethereisnoforeign
residue on the heating elements.
Rice is too hard or too
soft.
Rice is scorched.
The rice cooker
does not
automatically
switch to keep
warm mode.
• Electricheatingplateisdamaged.
• Notenoughortoomuchwater
has been added.
• Thericehasnotbeenrinsedwell.
• Mastertemperaturecontrolleris
defective.
• Mastertemperaturecontrolleris
defective.
• Takeyourappliancetoan
authorised service centre for
maintenance.
• Addwateraccordingtothescale
on the inside of the inner pot.
• Rinsethericeuntilwaterrunsclear.
• Takeyourappliancetoan
authorised service centre for
maintenance.
• Takeyourappliancetoan
authorised service centre for
maintenance.
• Powerwiringboardisdamaged.
• Circuitconnectionbreaksdown.
• Mastercircuitboardisdamaged.
• Electricthermaltubeisburntout.
• Thelightisdefective.
• Takeyourappliancetoan
authorised service centre for
maintenance.
Troubleshooting Guide
If the rice cooker does not function properly or if the cooking quality is insucient, refer to the table below.
EN