EasyManua.ls Logo

Electrolux ERES38820X - Closing the Door

Electrolux ERES38820X
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem Possible cause Solution
The mains plug is not connected
to the mains socket correctly.
Connect the mains plug to the
mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
Connect a another electrical ap-
pliance to the mains socket.
Check fuse. Contact a qualified
electrician.
Not enough carbon diox-
ide in the water.
The carbon dioxide is running
out.
Refer to "Installation of the gas
cylinder".
Too much carbon dioxide
in the water.
Dilute with ordinary water. Refer to "Selecting and dispens-
ing water".
No carbon dioxide.
The gas cylinder is empty. Refer to "Replacing gas cylinder"
No or very low water
flow.
Sediment in the water. Remove and clean the strainer in
the inlet hose connection.
Water supply obstructed. Check water supply.
Only gas comes out
when dispensing carbo-
nated water.
Sediment in the water. Remove and clean the strainer in
the inlet hose connection.
The water filter indicator
flashes.
The filter has been totally con-
sumed.
Refer to "Replacing the water fil-
ter".
The water filter indicator
lights constantly.
20% of filter capacity remains. Buy a new filter.
The water dispenser
lamp and the child lock
indicator flashes.
Internal leakage at the water
connection.
Contact your local Electrolux
Service Force Centre.
Leakage from filter operation. Open water module hatch and
dry up water from the bottom,
look for leakages.
If filter leaks, refer to "Replacing
the water filter"
Dispensing is interrupted
after a short time.
The maximum time of two mi-
nutes is exceeded.
Start new dispensing.
The lamp does not work.
The door has been open to long. Close the door.
The lamp is defective. Refer to "Replacing the lamp".
Door interferes with ven-
tilation grill.
The appliance is not levelled. Refer to "Levelling".
Misaligned door. The appliance is not levelled. Refer to "Levelling".
As much as the advice does not lead to result, call the nearest brand-mark service.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
electrolux 13

Related product manuals