7.4 Removing the transport support
2
3
Your appliance is equipped with transport
support to secure the door during trans-
portation.
To remove them do these steps:
• Open the door.
• Remove the transport support from the
door sides.
• Remove the transport support from the
lower hinge (some models).
Some models are fitted with a si-
lencing pad under the cabinet. Do
not remove this pad.
7.5 Rear spacers
• Install the spacers provided within the
accessory bag as shown in the figure.
• Install the spacers on the brackets of
the condenser (black grill) at the back of
the appliance.
7.6 Levelling
When placing the appliance ensure that it
stands level. If necessary adjust the feet
using the adjustment spanner supplied.
ENGLISH 33
To Next Page
Loading...
