Problem Possible cause Solution
Temperature set in the
appliance is too low and
the ambient temperature
is too high.
Set a higher temperature.
Refer to "Operation"
The compressor does not
start immediately after
pressing the "FastCool", or
after changing the temper‐
ature.
This is normal, no error
has occurred.
The compressor starts after
a period of time.
Water flows inside the re‐
frigerator.
Food products prevent
the water to flow into the
water collector.
Make sure that food prod‐
ucts do not touch the rear
plate.
The water outlet is clog‐
ged.
Clean the water outlet.
Water flows on the floor. The melting water outlet
is not connected to the
evaporative tray above
the compressor.
Attach the melting water out‐
let to the evaporative tray.
Temperature cannot be
set.
The "FastCool function"
is switched on.
Switch off "FastCool func‐
tion" manually, or wait until
the function resets automati‐
cally to set the temperature.
Refer to "FastCool function".
The temperature in the ap‐
pliance is too low/too high.
The temperature regula‐
tor is not set correctly.
Set a higher/lower tempera‐
ture.
The door is not closed
correctly.
Refer to "Closing the door".
The food products' tem‐
perature is too high.
Let the food products tem‐
perature decrease to room
temperature before storage.
Many food products are
stored at the same time.
Add less food products at
the same time.
The door has been
opened often.
Open the door only if neces‐
sary.
The "FastCool function"
is switched on.
Refer to "FastCool function".
There is no cold air circu‐
lation in the appliance.
Make sure that there is cold
air circulation in the appli‐
ance.
www.electrolux.com12
To Next Page
Loading...
