Electrolux ERT25G2HUG - Usage Instructions

How to use the refrigerator
01. When operating the refrigerator for
the first time, set the thermostat dial
at 3, connect the power cord and run
it without loading any food. Usually
this takes 2 or 3 hours. Then set the
thermostat at the desired setting and
place foods into the refrigerator.
02. The temperature of the refrigerator
can be adjusted by turning on the
thermostat, which has 7 settings.
The most suitable setting for general
operation would be 3-4. The higher
the setting, the lower the
temperature inside the refrigerator.
The variation in temperature of each
setting depends on ambient
temperature and where the
refrigerator is positioned.
03. Do not put too many foods in the
refrigerator. Open the door lesser in
order to maintain the temperature of
the refrigerator and save energy
comsumption
04. When making ice cubes, fill the ice
tray with drinkable water and put it
into the freezer. It takes about 2 or 3
hours to make ice cubes. Pieces of
ice cube can be removed by twisting
it. Do not press it up and down,
otherwise it may be broken.
05. Defrost the freezer whenever the
layer of frost on the surface reaches
3 or 4 mm. When defrosting, remove
all foods and appendix, set the
thermostat at 0 position and open
Usage instructions
ENG ENG
Electric parts of the refrigerator can
only be wiped by dry cloth.
3
4
5
Setting
Refrigerator Freezer
1
2
3
4
5
6
7
5ºC to 10ºC
4ºC to 10ºC
3ºC to 8ºC
2ºC to 8ºC
0ºC to 7ºC
-1ºC to 5ºC
-3ºC to 3ºC
-16ºC to -10ºC
-17ºC to -13ºC
-19ºC to -15ºC
-20ºC to -15ºC
-21ºC to -17ºC
-22ºC to -17ºC
-25ºC to -18ºC
13 electrolux installation
usage instructions electrolux 14
Grounding
The power cord has a three-pronged
grounded plug for your personal safety.
It must be connected to a grounding
type
wall receptacle, in accordance with the
legislation governing electric
installations
in your country, as well as any local
regulations. Do not remove the
grounding prong, do not use a two
pronged adaptor, and never make a
connection to the schematic. Use the
cord supplied with the equipment (do
not change it). If the cord is damaged, it
must be immediately replaced by
specialized personnel.
For your safety, installation must be
grounded. If it is not grounded, it
must be adapted for this by
specialized personnel.
Attention
Attention