Electrolux ERW1573AOA - Page 13

13
ENGLISH
Iftheinstallationsiterequires.Toolsyou
willneed:
1. Cross-shapedscrewdriver
2. Puttyknifeorthin-bladescrewdriver
Beforeyoustartlaythewinecooleronits
backinordertogainaccesstothebase,
youshouldrestitonsoftfoampackaging
orsimilarmaterialtoavoiddamagingthe
coolingpipesattherearofthewine
cooler.
3. Standthewinecooler,openthedoor
andremovetheshelvesandcloseit
(preventingtheshelvesaredam-
aged).
4. Removethebottomhingebyun-
screwingthefourlockscrews.Be
carefultoholdtheglassdoorrmly
afterremovingthescrews.
5. Gentlyremovetheupperdoorand
set it on a non scratching surface
withtheoutsideuptoavoidtherisk
ofdamage.
NOTE:Whenremovingthedoor,watch
forwasher(s)betweentheceterhinge
andthebottomofthefreezerdoorthat
maysticktothedoor.Donotlose.
6. Unscrewtheupperhingewhichat
thetoprightcornerofthewinecooler,
and then use a putty knife or thin
bladescrewdrivertoprizethescrew
holecoverwhichattheleftside
comerofthewinecooler,re-cover
thescrewholesontherighthand
side.
7. Screwthealternativelefttophinge
(includedinthettings)tothetopleft
cornerofthewinecoolerandtighten
securely.
ERW1573AOA_Wine_cellar_ELUX_EN_CZ_DA_FI_FR_NO_PL_RU_SK_SV.indd 13 06-07-2020 05:43:04 PM