Electrolux ESB5400BK - English

6 www.electrolux.com
ENGLISH
Thank you for choosing an Electrolux product. In order to ensure the best results, always use original Electrolux
accessories and spare parts. They have been designed especially for your product. This product is designed with
the environment in mind. All plastic parts are marked for recycling purposes.
COMPONENTS
A. Jug
B. Spout
C. Lid with ller hole
D. Measuring cup
E. Blade assembly, detachable
F. Motor housing
G. Speed selector (with PULSE, ICE CRUSH function)*
H. Cord storage device (underside of appliance)
I. Non-slip feet
*depending on model
Picture pages 2-3
GETTING STARTED (*depending on model )
1 Before using the blender for the rst time, wash all parts except for the motor housing. Assembling: Place the
rubber seal on the blade assembly (A) and insert it under the jug. Turn the blade assembly counter-clockwise (B)
to fasten.
Caution! The blades are very sharp!
2 Place the blender on a at surface and lock the jug into position on the motor housing. When the arrow is
aligned with the “Locked” indicator, the jug is locked in position. Put the ingredients in the jug. (Do not exceed
the maximum level as indicated on the jug.)
3 Close the lid (A) and insert the measuring cup in the ller hole and (B) lock into position. (You can use the
measuring cup to add ingredients while the blender is running. Close the ller hole immediately after, to avoid
splashing.)
Caution! When processing hot liquids, see paragraph 4.
4 Processing hot liquids: allow hot liquids to cool down until lukewarm before lling the jug. Fill the jug only
half full and start processing on low speed. The blender jug can become very warm – take care to protect your
hands and to ventilate steam out through the ller hole. Always replace the lid before use.Push and hold the
On-O button to start mixing. The indicator light will illuminate until the On-O button is released. Release the
On-O button to stop mixing. Caution! If the motor stalls, turn the blender o immediately, unplug the appli-
ance and let it cool for at least 10 minutes.
5 Start the blender: Make sure the speed selector is set to the “OFF”-position. Plug into mains. Turn the speed
selector to your desired setting.* The LED light turns on when you operate the speed selector.*
Note: Turn the speed selector to “PULSE, ICE CRUSH” without releasing it, to accelerate the process of blending.
Release to stop.
6 Ice crushing: Turn the speed selector to “PULSE, ICE CRUSH” for 3-5 seconds several times until you obtain a
satisfactory result.
Note: You can add more ice through the ller hole while the blender is running.
CLEANING AND CARE
7 Quick cleaning: Pour warm water into the jug, add a few drops of detergent. Mix water and detergent by turning
the speed selector to “PULSE, ICE CRUSH” briey. Finally, rinse the jug under running water.
8 Thorough cleaning: Turn the blender o and unplug the power cord. Wipe the motor housing with a damp
cloth.
Warning! Never immerse the housing, plug, and cord in water or any other uid
9 TRemove the lid and jug. Turn the blade assembly clockwise and remove it. Rinse the blade assembly in water
and detergent. Caution! Handle carefully, the blades are very sharp! The lid, jug and measuring cup can be
washed in the dishwasher.
Enjoy your new Electrolux product!