18
Setting the dishwashing programme
1. Check that the dishes and cutlery are loaded into
the dishwasher in such a manner that the spray
arms are free to rotate.
2. Open the tap fully.
3. Close dishwasher door.
4. Turn the programme switch clockwise to A or B
(see „ Programme Table“).
1
For interference suppression reasons, only
operate the programme switch with the dish-
washer switched off. It is also possible that
the automated addition of detergent will be
triggered.
5. Press the button for the programme required
(see „ Programme Table“).
6.
Press ON/OFF button a. Power indicator
light illuminates. The selected wash pro-
gramme starts.
The programme switch rotates during the
wash programme and indicates the position
that has been reached in the programme.
1
If a wash programme has been started even
though the tap was closed, switch off the
dishwasher with the ON/OFF button
a,
open the tap and start the wash programme
again.
Changing/Interrupting the Wash
Programme
3
Only change or interrupt a wash programme
in progress if it is absolutely necessary.
When the appliance is closed again, the air
that has entered is heated rapidly and
expands. This can cause water to escape
onto the floor and possibly trigger the anti-
flood system.
Changing the wash programme
1. Press ON/OFF button a. Power indicator light
goes out, wash programme stops.
1
Hot steam can escape when the door is
opened. There is a risk of scolding! Open the
door carefully.
2. Open dishwasher door and check whether there is
still detergent in the container. Refill the container
if necessary.
3. Close dishwasher door.
4. Turn the programme switch clockwise to A or B
(see „ Programme Table“).
5. Press the button for the programme required
(see „ Programme Table“).
6. Press ON/OFF button
a.ON/OFFbuttona
indicator illuminates. The selected wash pro-
gramme starts.
Interrupting the wash programme by
opening the door of the dishwasher
1
Hot steam can escape when the door is
opened. There is a risk of scolding! Open the
door carefully.
1. Open the door of the dishwasher. The wash pro-
gramme stops.
2. Shut the door. The wash programme continues.
Switching Off the Dish-
washer
When the wash programme is finished:
1. Press the ON/OFF button
a . Power indicator
light goes out.
1
Hot steam may escape if the door is opened
immediately after the end of the programme.
Therefore:
2. Open the door carefully.
Emptying the Dishwasher
3
• Hot dishes are sensitive to knocks. The dishes
should therefore be allowed to cool down before
removing them from the appliance.
• Leave the dishes in the dishwasher for approx. 15
minutes after the end of the programme so that
they dry better and can cool down.
• Empty the lower rack first, then the upper rack. In
this way you will avoid any water left on the upper
rack dripping onto the dishes in the lower rack and
causing water spots.
1
Please note, that if your dishwasher is
installed under a kitchen worktop, escaping
steam may damage the worktop. Its under-
side must be protectad against rising steam
with aluminium foil as prescribed.
To Next Page
Loading...
