18
Electrolux 818 19 47-00/6
To Change the Light Bulb
The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
Raise the lamp grille.
Use a bulb of the same type, E14 socket, maximum
ratingof25W.
When replacing the light bulb, use a bulb of the
same type as the original one. The glass must
measure at least 18 mm in diameter at the socket.
This will ensure close fitting of the bulb against the
rubber seal in the socket.
When the appliance is not in use
Disconnect the appliance from electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food inside
from spoiling in case of a power failure.
Something Not Working
GB
Before contacting your local Service Force C entre check the following point:
Problem Possible cause / Remedy
It is too warm inside the freezer. Set a lower temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
If warm food products have been put inside the freezer, wait for
a couple of hours and then check the temperature again.
Distribute the food products to allow cold air to circulate
around them.
It is too cold inside the freezer. Set a warmer temperature.
Too much frost and ice are produced. Make sure that the door is completely closed and that the
insulating strip is complete and clean.
Set a warmer temperature.
The compressor operates continuously. Set a warmer temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
The temperature where the cabinet is placed is above normal
room temperature.
The cabinet does not operate at all.
Cooling or interior light does not
operate. No indicator lamps light.
The cabinet is not switched on.
Power does not reach the cabinet. (T ry connecting another
electrical device to the power outlet.)
The fuse has blown.
The power plug is not properly connected.
To Next Page
Loading...
