DOC. NO. 5956.65J.00 P. 105 / 174
EFS - Dishwashing Systems Platform
Electrolux Professional
To set the board parameters , carefully follow the order given in this programming file, from point 1 to
point 7.
When modifying parameter , all the parameters (except those belonging to the family)
assume the default values according to the tables in section 11 DEFAULT VALUES. The parameters of
the family are not modified.
EUC3DPCAG PROG 138
Drain parameters family.
Initial Drain Phase Duration [s].
Final Drain Phase Duration [s].
Drain and cleaning mode.
Number of wash cycles possible between one drain cycle and the next.
Set other parameters.
Initial Pause [s] (for ALL cycles).
Delay for the 2
nd
wash pump [s].
Drain Phase Duration at the end of washing phase [s].
Duration of pause after the rinse cycle [s] (for ALL cycles).
Degrees Celsius display.
During the rinse stage, the display shows the boiler temperature.
Enter into HCP parameter family and set the following parameters.
Machine arranged for remote connection to PC.
6. Switch OFF and then switch ON the machine.
Enter into GEn parameter family.
Initial Detergent Dosage.
Initial Rinse Aid Dosage.
Detergent dispenser works when LOAD SOLENOID VALVE in activated.
Rinse Aid dispenser works when LOAD SOLENOID VALVE in activated.
7. Switch OFF and then switch ON the machine.
To Next Page
Loading...
Need help?
General
