DOC. NO. 5956.65J.00 P. 71 / 174
EFS - Dishwashing Systems Platform
Electrolux Professional
To set the board parameters , carefully follow the order given in this programming file, from point 1 to
point 7.
When modifying parameter , all the parameters (except those belonging to the family)
assume the default values according to the tables in section 11 DEFAULT VALUES. The parameters of
the family are not modified.
ZHTAWS - AHTAWS - EHTAWS
PROG 121
Drain parameters family.
Initial Drain Phase Duration [s].
Final Drain Phase Duration [s].
Drain and cleaning mode.
Wash tank water change frequency control disabled.
Set other parameters.
Initial Pause [s] (for ALL cycles).
Delay for the 2
nd
wash pump [s].
Drain Phase Duration at the end of washing phase [s].
Duration of pause after the rinse cycle [s] (for ALL cycles).
Degrees Celsius display.
During the rinse stage, the display shows the boiler temperature.
Enter into HCP parameter family and set the following parameters.
Dishwasher with incorporated continuous water softener.
6. Switch OFF and then switch ON the machine.
Enter into GEn parameter family.
Initial Detergent Dosage.
Initial Rinse Aid Dosage.
Detergent dispensing during the wash cycle (loading during wash stage).
Rinse aid dispensing during the rinse cycle (loading during boiler filling stage).
7. Switch OFF and then switch ON the machine.
To Next Page
Loading...
Need help?
General
