Electrolux EUT700AOW - Safety Instructions

4 www.electrolux.com
Installation
WARNING!
Only a qualied person must
install this appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Obey the installation instruction
supplied with the appliance.
• Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
• Make sure the air can circulate around
the appliance.
• Wait at least 4 hours before
connecting the appliance to the power
supply. This is to allow the oil to ow
back in the compressor.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand
against the wall.
• Do not install the appliance where
there is direct sunlight.
• Do not install this appliance in areas
that are too humid or too colds, such
as the construction appendices,
garages or wine cellars.
• When you move the appliance, lift it
by the front edge to avoid scratching
the oor.
Electrical connection
WARNING!
Risk of re and electrical shock.
WARNING!
When positioning the appliance,
ensure the supply cord is not
trapped or damaged.
WARNING!
Do not use multi-plug adapters
and extension cables.
• The appliance must be earthed.
• All electrical connections should be
made by a qualied electrician.
• Make sure that the electrical informa-
tion on the rating plate agrees with
the power supply. If not, contact an
electrician.
• Always use a correctly installed shock-
proof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to
the electrical components (e.g. mains
plug, mains cable, compressor).
Contact the Service or an electrician to
change the electrical components.
• The mains cable must stay below the
level of the mains plug.
• Connect the mains plug to the mains
socket only at the end of the installa-
tion. Make sure that there is access to
the mains plug after the installation.
SAFETY INSTRUCTIONS
• Clean the appliance with a moist soft cloth. Only use neutral deter-
gents. Do not use abrasive products, abrasive cleaning pads, solvents
or metal objects.
• Do not store explosive substances such as aerosol cans with a am-
mable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by the manufac-
turer, its service agent or similarlyqualied persons in order to avoid a
hazard.
• If the appliance is equipped with an Ice maker or a water dispenser, ll
them with potable water only.
• If the appliance requires a water connection, connect it to potable
water supply only.
• The inlet water pressure (minimum and maximum)must be between 1
bar (0,1 MPa) and 10 bar (1 MPa)