9
BEFORE USING THE APPLIANCE
1. Insert the twin pegged side into the rear access holes
provided, ensuring pegs are fully inserted.
2. Then locate the front peg into the front access hole
and push in firmly.
The shelves are designed so that they have maximum
extension but cannot be accidentally pulled right out. The
grill dish carrier is designed the same way and can slot
straight into the side racks.
To fit a shelf or grill dish carrier to side racks:
1. Locate the rear edge of the shelf/carrier in between
guide rails of the side rack - see diagram.
2. Ensure the same rail positions on both sides of the
oven are being engaged. With the front edge raised,
begin to slide the shelf into the oven.
3. Once the detents have passed the front edge of the
side rack, the shelf can be pushed completely in.
When fully inserted the shelf/carrier should not interfere
with the closed oven door.
To fit a shelf or grill dish carrier to telescopic slides:
1. With the slides fully pushed in, push the shelf/carrier
along the top of the slide until it hits the back post.
2. Drop the front of the shelf/carrier ensuring it sits
behind the front post of the slide (see illustration).
When fully inserted the shelf/carrier should not
interfere with the closed oven door.
To Next Page