16
Water inlet filter
If you notice that the machine is taking longer to
fill, check that the filter in the water inlet hose is
not blocked.
Turn off the water tap.
Unscrew the hose from the tap and remove the
filter.
Clean it with a stiff brush.
Refit the filter and screw the hose back onto the
tap.
The dangers of freezing
If the machine is exposed to temperatures below
0°C, certain precautions should be taken.
■
Turn off the water tap.
■
Unscrew the inlet hose.
■
Unhook the drain hose from the rear support
and position the end of this hose and that of
the inlet hose in a bowl. Run the draining
programme until the selector dial is in the
“Stop” position.
■
Disconnect the appliance.
■
Screw the inlet hose and reposition the drain
hose.
■
When you intend to start the machine up
again, make sure that the room temperature
is above 0°C.
To Next Page
Loading...
Need help?
General
