5. Remove the polystyrene protection from
the bottom. Put the appliance back into an
upright position.
6. Remove the power supply cable and the
drain hose from the hose holders.
It is possible to see water flowing from the
drain hose. This is because the washing
machine has been tested at the factory.
7. Remove the three transit bolts and pull
out the plastic spacers.
8. Put the plastic caps, that you find in the
user manual bag, in the holes.
We recommend that you
keep the packaging and the
transit bolts for any transport
of the appliance.
3.2 Positioning and levelling
1. Install the appliance on a flat hard
floor.
Make sure that the appliance
does not touch the wall or
other units.
2. Loosen or tighten the feet to adjust
the level.
WARNING!
Do not put cardboard, wood
or equivalent materials
below the appliance feet to
adjust the level.
The appliance must be level and stable.
A correct adjustment of the
appliance level prevents the
vibration, noise and the
movement of the appliance
when in operation.
ENGLISH 7
To Next Page
Loading...
