Electrolux EW6F4923EB - Page 20

Make sure that the flap does not cause a
blockage when you close the drawer.
10.5 Setting a programme
1. Turn the programme dial to select the
desired washing programme.
The indicator of the Inicio/Pausa
button flashes.
The display shows an indicative
programme duration.
2. To change the temperature and/or
the spin speed, touch the related
buttons.
3. If desired, set one or more options by
touching the related buttons. The
related indicators illuminate on the
display and the given information
changes accordingly.
If a selection is not possible
an acoustic signal sounds.
10.6 Starting a programme
Touch the Inicio/Pausa button to start
the programme.
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
10.7 Starting a programme with
the delay start
1. Touch the Inicio Diferido button
repeatedly until the display shows the
desired delay time. On the display the
indicator shows .
2. Touch the Inicio/Pausa button.
The appliance door locks and starts the
countdown of the delay start. The display
shows the indicator .
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Inicio/Pausa button to
pause the appliance. The related
indicator flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows
and the indicator goes off.
3. Touch the Inicio/Pausa
button
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Inicio/Pausa button to
pause the appliance. The related
indicator flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows the
desired delay time.
3. Touch the Inicio/Pausa button
again to start the new countdown.
10.8 The SensiCare System
load detection
After touching the Inicio/Pausa
button:
1. The SensiCare System starts
estimating the weight of the load to
calculate the real programme
duration. During this phase the Time
Manager bars placed below the
time digits play a simple animation.
www.electrolux.com20