3. INSTALLATION
WARNING!
Refer to Safety chapters.
3.1 Unpacking
1. Remove the external film. If necessary,
use a cutter.
2. Remove the cardboard top and the
polystyrene packaging materials.
3. Open the door. Remove all the items from
the drum .
4. Put the front polystyrene packaging
element on the floor under the appliance.
Carefully put down the appliance onto its rear
side.
5. Remove the polystyrene protection from
the bottom. Put the appliance back into an
upright position.
6. Remove the power supply cable and the
drain hose from the hose holders.
It is possible to see water flowing from the
drain hose. This is because the washing
machine has been tested at the factory.
www.electrolux.com6
To Next Page
Loading...
