Electrolux EW6F5922EF - Page 21

Make sure that the flap does not cause a
blockage when you close the drawer.
11.5 Setting a programme
1. Turn the programme dial to select the
desired washing programme.
The indicator of the Inicio/Pausa
button flashes.
The display shows an indicative
programme duration.
2. To change the temperature and/or
the spin speed, touch the related
buttons.
3. If desired, set one or more options by
touching the related buttons.
If a selection is not possible
an acoustic signal sounds.
11.6 Starting a programme
Touch the Inicio/Pausa button to start
the programme. It is not possible to start
the programme when the indicator of the
button is off and doesn't flash (e.g.
programme dial on a wrong position).
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
11.7 Starting a programme with
the delay start
1. Touch the Inicio Diferido button until
the display shows the desired delay time.
The related indicator comes on.
2. Touch the Inicio/Pausa button. The
appliance door locks and starts the
countdown of the delay start. The display
shows the indicator .
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Inicio/Pausa
button to
pause the appliance. The related
indicator flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows .
3. Touch the Inicio/Pausa button
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Inicio/Pausa
button to
pause the appliance. The related
indicator flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows the
desired delay time.
3. Touch the Inicio/Pausa
button
again to start the new countdown.
11.8 The SensiCare System
load detection
After touching the Inicio/Pausa
button:
1. The SensiCare System starts
estimating the weight of the load to
calculate the real programme
duration. During this phase the two
dots separating hours from minutes
are blinking
2. After about 15-20 minutes new cycle
duration is displayed.
The appliance automatically adjusts
the programme duration to the load
to achieve perfect washing results in
the minimum possible time.
ENGLISH 21