Problem Possible solution
Too much foam in the
drum during the wash‐
ing cycle.
• Reduce the quantity of detergent.
After the washing cycle,
there are some deter‐
gent residues in the dis‐
penser drawer.
• Make sure that the flap is in the correct position (UP for
powder detergent - DOWN for liquid detergent).
• Make sure you have used the detergent dispenser ac‐
cording the indications given in this user manual.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes, deactivate and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
15. CONSUMPTION VALUES
Stated values are obtained in laboratory conditions with relevant stand‐
ards. Different causes can change the data: the quantity and type of
laundry and ambient temperature. Water pressure, the supply voltage
and the temperature of inlet water may also affect the washing pro‐
gramme duration.
Technical specifications may be changed without prior notice to improve
the quality of product.
Programmes Load
(kg)
Energy
con‐
sumption
(kWh)
Water
con‐
sumption
(litre)
Approxi‐
mate pro‐
gramme
duration
(minutes)
Remain‐
ing mois‐
ture (%)
1)
Algod. 60°C 9 1,58 84 240 53
Algod. 40°C 9 1,30 82 210 53
Sintéticos 40°C 4 0,74 61 140 35
Delicados 40°C 4 0,54 62 95 35
Lana/Lãs 30°C 1,5 0,42 62 75 30
Standard cotton programmes
Standard 60°C cotton
9 0,95 53 248 53
Standard 60°C cotton
4,5 0,64 43 209 53
Standard 40°C cotton
4,5 0,61 44 205 53
1)
At the end of spin phase.
www.electrolux.com30
To Next Page
Loading...
