EasyManua.ls Logo

Electrolux EW6T4261 - Troubleshooting; Troubleshooting Introduction

Electrolux EW6T4261
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Programmes Load
(kg)
Energy
con‐
sumption
(kWh)
Water
con‐
sumption
(litre)
Approxi‐
mate pro‐
gramme
duration
(minutes)
Remain‐
ing mois‐
ture (%)
1)
Delicates 40°C 2,5 0,55 46 90 35
Wool 30°C 1 0,35 50 65 30
Standard cotton programmes
Standard 60°C cotton
6 0,80 43 247 53
Standard 60°C cotton
3 0,54 33 185 53
Standard 40°C cotton
3 0,49 34 179 53
1)
At the end of spin phase.
Off Mode (W) Left On Mode (W)
0.48 0.48
The information given in the chart above is compliant with the EU Commission regu‐
lation 1015/2010 implementing directive 2009/125/EC .
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 Introduction
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists,
contact the Authorised Service Centre.
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
alarm code and the Start/Pause button may flash continuously:
- The mains supply is unstable. Wait until the mains supply is stable.
- No communication between electronic elements of the appliance. Switch it
off and switch on again. The programme was not finished properly or the appliance
stopped too early. If the alarm code appears again, contact the Authorised Service
Centre.
- The appliance does not fill with water properly. After the proper check, start
the appliance again by pressing Start/Pause
button the appliance tries to
resume the cycle . If the error persists the alarm code will appear again.
- The appliance does not drain the water.
www.electrolux.com24

Related product manuals