EasyManua.ls Logo

Electrolux EW6T4722AF - Technical Data

Electrolux EW6T4722AF
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem Possible solution
The appliance makes
an unusual noise and
vibrates.
Make sure the levelling of the appliance is correct. Refer
to "Installation instruction".
Make sure that the packaging and/or the transit bolts
are removed. Refer to "Installation instruction".
Add more laundry in the drum. The load may be too
small.
The programme dura‐
tion increases or de‐
creases during pro‐
gramme execution.
The SensiCare System is able to adjust the programme
duration according to the type and the laundry load size.
Refer to "The SensiCare System load detection" in "Dai‐
ly Use" chapter.
The washing results are
not satisfactory.
Increase the detergent quantity or use a different deter‐
gent.
Use special products to remove the stubborn stains be‐
fore you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Too much foam in the
drum during the wash‐
ing cycle.
Reduce the quantity of detergent.
After the washing cycle,
there are some deter‐
gent residues in the dis‐
penser drawer.
Make sure that the flap is in the correct position.
Make sure you have used the detergent dispenser ac‐
cording the indications given in this user manual.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes, deactivate and activate the
appliance. If the problem continues, contact the Authorised Service
Centre.
14. TECHNICAL DATA
Dimension Width/ Height/ Depth/
Total depth
400 mm/ 890 mm/ 600 mm/ 600
mm
Electrical connection Voltage
Overall power
Fuse
Frequency
220-230 V
2200 W
13 A
50 Hz
Level of protection against ingress of solid parti‐
cles and moisture ensured by the protective cov‐
er, except where the low voltage equipment has
no protection against moisture
IPX4
Water supply pressure Minimum
Maximum
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
www.electrolux.com28

Related product manuals