13.1 Introduction
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists,
contact the Authorised Service Centre.
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
alarm code and the Start/Pause button may flash continuously:
•
- Frequency of power supply out of range.
• - Supply voltage too high.
• - Supply voltage too low.
•
- Internal fail. Switch if Off and switch on again. The programme was not
finished properly or the appliance stopped too early. If the alarm code appears
again, contact the Authorized Service Center and communicate the warning.
• - The appliance does not fill with water properly. After the proper check, start
the appliance again by pressing Start/Pause button the appliance tries to
resume the cycle . If the error persists the alarm code will appear again.
• - The appliance does not drain the water.
• - The appliance door is open or not closed correctly. Please check the door!
If the appliance is overloaded, remove some items from the drum
and/or hold the door shut while touching the Start/Pause button
until the indicator stops flashing (see the picture below).
www.electrolux.com46
To Next Page
Loading...
