or lack of experience and knowledge, un-
less they have been given supervision or
instruction concerning use of the appli-
ance by a person responsible for their
safety.
Children should be supervised to ensure
that they do not play with the appliance.
HOW TO RUN A WASH CYCLE?
USING FOR THE FIRST TIME
• Ensure the electrical and water con-
nections comply with the installation
instructions.
• Remove the polystyrene insert and
all other items inside the drum.
• Run an initial wash cycle at 90°C,
without any washing but with deter-
gent to clean the water tank.
DAILY USE
LOADING WASHING
A
A
• Open the lid of the appliance.
• Open the drum by depressing the locking
button A
1)
: The two shutters unlock au-
tomatically.
• Load the washing, close the drum and
the lid of your washing machine.
Warning! Before closing the lid of your
appliance, ensure that the drum is
properly closed :
• When the two shutters are closed,
• locking button A released.
PROPORTIONING OF DETERGENTS
Pour the amount of washing into the wash-
ing
and prewash compartments if
you have selected the “prewash” option.
Pour fabric softener into the compartment
if necessary.
SELECTION OF DESIRED
PROGRAMME
Turn the programme selector to the re-
quired programme. The “Start/Pause”
pushbutton flashes green.
If you turn the programme selector to an-
other programme while a cycle is in pro-
gress, the appliance will ignore the new se-
lected programme. The “Start/Pause”
pushbutton flashes red for a few seconds.
SELECTING THE TEMPERATURE
Press the “Temperature”
pushbutton re-
peatedly to increase or decrease the tem-
perature (see “Programmes table”). The
symbol means a cold wash.
SELECTING THE SPIN SPEED
Turn the spin speed selector on the desired
position.
The maximum spin speeds are :
for Cottons, Synthetics, Lingerie, Wool/
Handwash, Eco, Easy iron : 900 rpm
(EWB96210W), 800 rpm (EWB86210W),
700 rpm (EWB76210W), for Delicates, Mini
programme, Curtains, Blanket : 700 rpm.
At the end of the programme, if you have
selected “Rinse hold”
or “Night silence
plus”
, you then need to select a “Spin”
or “Drain” programme to finish the cy-
cle and empty the water.
SELECTING OPTIONS
You must select the different options after
selecting the programme and before press-
ing the “Start/Pause”
pushbutton (see
“Programmes table”). Press the desired
button(s) : the corresponding lights come
on. If pressed again, the lights go out. If one
of the options is not compatible with the se-
lected programme, the “Start/Pause”
pushbutton flashes red.
1) Depending on model.
4 electrolux
To Next Page