87
ENGLISH
The lights corresponding to the different phases
making up the selected programme light on.
The light of the “Start/Pause” button starts to flash.
5. Select the temperature
Press the “Temp.” button if you wish to select a
temperature value different from the one proposed
by the washing machine. The relevant light will light
up.
6. Select the spin speed or the
option
Press the “Spin” button repeatedly button if order to
select the desired spin speed or the option.
The relevant light will light up.
EWF 1620 EWF 1420
EWF 1220
7. Select the required options
The light corresponding to the depressed button
illuminates.
Operating sequence
Before the first wash we recommend that you pour 2
litres of water into the main wash compartment
of the detergent drawer in order to activate the ECO
valve. Then run a cotton cycle at 95°C, with the
machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment .
If you have selected the prewash or the stain option,
pour detergent or stain remover into the appropriate
compartment marked .
3. Measure out the additive
If required, pour fabric softener into the
compartment marked , without exceeding the
«MAX» mark.
4. Select the desired programme
Switch the machine on turning the programme
selector dial to the desired position. To switch the
appliance off turn it to “Off”.
To Next Page
Loading...
