88
7. Select the “Delay start”
Before you start the programme, if you wish the
start to be delayed, press the “Delay Start” button
repeatedly, or keep it pressed, to select the desired
delay. The selected delay time value (up to 23 hours)
will appear on the display for 3 seconds, then the
duration of the programme will appear again.
8. Start the programme
Depress “Start/Pause”-button, the corresponding
pilot light stops flashing. The the pilot light
“Washing” remains lit.
9. Altering an option or a programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the “Start/Pause”
button.
Changing a running programme is possible only by
resetting it.
Turn the programme selector dial to “Off” and then
to the new programme position. The washing water
in the tub will not emptied out .
Start the new programme by depressing the
“Start/Pause” button.
10. Interrupting a programme
Depress the “Start/Pause” button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the same button again to
restart the programme.
11. Cancelling a programme
Turn the selector dial to “Off” to cancel a
programme which is running.
Now you can select a new programme.
12. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
“Start/Pause” button.
If the door does not open, this means that the water
temperature is above 55°C, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
programme selector dial to “Off”. After about 3
minutes the door can be opened (pay attention to
the water level and temperature!).
Select the programme again and depress
“Start/Pause” to restart it.
13. At the end of the programme
The machine stops automatically.
If the anti-crease
o
r options have been
selected, the “Start/Pause” goes out, the door is
locked and the “End” light up to indicate that the
water must be emptied out before opening the door.
To do this turn the programme selector dial to “Off”
and then to programme
“Drain” or “Spin”. The spin
programme is performed at the maximum speed. In
order to avoid any creasing in synthetic, delicate and
wool items, the spin reduction option must be
selected.
Release of the lock is also indicated by the coming
on of the “End” light.
Switch the machine off by turning the programme
selector dial to “Off”.
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
To Next Page
Loading...
