79
ENGLISH
Use
1 Programme selector dial
The selector is divided into 5 sections:
• Cotton
• Synthetic
• Delicate
• Wool
• Special programmes
UIT/ARRET Reset programme/OFF
The selector dial can be turned either clockwise or
anticlockwise.
Position ECO-60° corresponds to the ENERGY
SAVING programme and position to “cold wash”.
At the end of the programme the selector dial
must be turned to position UIT/ARRET.
ATTENTION!
If you turn the programme selector dial to another
programme when the machine is working, all the
lights of the programme progress display will flash
for about 2 seconds, an acoustic signal will be heard
but the washing machine will not perform the new
selected programme.
2 Night Cycle button
When you choose this option, the machine will not
drain the water of the last rinse, so as not to crease
the laundry.
As all spinning phases are cancelled, this washing
cycle is very quiet and it can be useful at night or in
hours with more economical power rate.
The machine will perform 3 additional rinses on
cottons and 1 additional rinse on synthetics
programmes.
At the end of the cycle, the light corresponding to
the option is on, the “Start/Pause” (Start/Pauze
- Marche/Pause) button light goes out, the “End”
light light up (Einde - Fin) and the door cannot be
opened to indicate that the water must be drained.
A blinking zero will appear on the display.
To empty out water there are 2 possibilities:
-Select
“
Drain” (Afpompen - Vidange) programme
:
the water is emptied out without spinning.
-Select the “Spin” (Centrifug. - Essorage)
programme. Select the spin speed by means of
the relevant button and then depress the
“Start/Pause” button . The water is emptied out
and the laundry is spun at the selected spin
speed.
Attention!
Before selecting
“
Drain” programme, or “Spin”
programme the selector dial has to be positioned on
“Off” (UIT/ARRET).
To Next Page
Loading...
