12
4. Select the required programme
Turn the programme selector dial to the required
programme. The light of the START/PAUSE button
starts to flash
.
5. Select the required options
The light corresponding to the depressed button
illuminates.
6. Select the spin speed or option
Depress the spin speed button to choose the
required speed or option : the corresponding
light comes on.
EWF 810 EWF1010
Operating sequence
Before the first wash we recommend that you pour 2
litres of water into the main wash compartment
of the detergent drawer in order to activate the ECO
valve. Then run a cotton cycle at 60°C, with the
machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment .
If you wish to carry out the prewash, pour detergent
or the stain remover into the appropriate
compartment marked .
3. Measure out the additive
If required, pour fabric softener into the
compartment marked , without exceeding the
«MAX» mark.
To Next Page
Loading...
