use electrolux 13
The display shows the following
information:
After selecting a programme, the
estimate time is displayed in hours and
minutes (for example 2.05).
The estimate time is calculated
automatically on the basis of the
maximum recommended load for each
type of fabric.
After the programme has started, the
time remaining is updated every minute.
The selected delay (20 hours max) set
by means of the relevant button appears
on the display for about 3 seconds, then
the duration of the previously selected
programme is displayed.
The delay time value decreases by one
unit every hour and then, when 1 hours
remain, the time decreases every minute.
Estimated time of the selected
programme
Display
Delayed start
If an option which is not compatible with
the set wash programme is selected, the
message is displayed for about 2
seconds and the integrated red
Start/Pause light start flashing.
In the event of operating problems,
some alarm codes can be displayed, for
example E20 (see paragraph “Something
not working”).
Incorrect option selection
Alarm codes
EN
To Next Page
Loading...
