6 www.electrolux.com
remaining (8, 7.5, 7, etc.) until the unit
either starts or stops.
For the Delay Start, the fan speed
and humidity maintained will be the
same as previous setting. After TIMER
setting finishes, pressing TIMER
button again at any time will stop the
TIMER function. The Delay Start/Stop
Feature will work until the unit either
starts or stops. Once that happens the
above steps have to be repeated.
– Before entering TIMER setting, make
sure power is being supplied to the
unit.
– Before entering TIMER setting,
make sure pressing HUMIDITY
or button sets one desired room
humidity first.
7. To shut the unit down, press the ON/
OFF button .
Fault codes
If the display reads "AS" or "ES" , a sensor
has failed. Contact your Authorized
Service Center.
Removing collected water
1. Emptying the Bucket:
– When the bucket is full, the unit will
shut down and the BUCKET FULL
indicator will illuminate.
– Do not move the unit at this time
otherwise water may spill on the
floor.
– Press sides of bucket gently to
unclip the bucket from the unit.
– Remove the bucket as shown in the
photographs below and empty the
bucket.
– Replace the empty bucket back into
the unit and once seated correctly,
the unit will start up again.
– You should hear a click when the
bucket is in the correct position
Warning! Discard water from
bucket. Water is not potable and
cannot be used for drinking.
To Next Page
Loading...
