Electrolux EXO27HEIWE - Page 26

26 www.electrolux.com
To set the Auto-off time.
1. Press the TIMER OFF button. The
remote controller shows TIMER OFF,
the last Auto-off setting time and
the signal “h” will be shown on the
LCD display area. Now it is ready to
reset the Auto-off time to START the
operation.
2. Push the TIMER OFF button again
to set desired Auto-off time. Each
time you press the button, the time
increases in 30 minutes increments, up
to 10 hours, then at 1 hour increments
up to 24 hours.
3. After setting the TIMER OFF, there will
be a one-half second delay before
the remote controller transmits the
signal to the air conditioner. Then, after
approximately another 2 seconds, the
signal “h” will disappear and the set
temperature will re-appear on the LCD
display window.
The effective operation time set by
the remote controller for the timer
function is limited to the following
settings: 0.5, 1.0, 1.5, 2.0, 2.5,
3.0, 3.5, 4.0, 4.5, 5.0, 5.5, 6.0,
6.5, 7.0, 7.5, 8.0, 8.5, 9.0, 9.5, 10,
11, 12, 13, 14, 15, 16, 17, 18, 19,
20, 21, 22, 23 and 24.
Example of Timer setting
Fig.07
Fig.08
Fig.08
Fig.10
h
TIMER ON
Off
Start
Set
6 hours later
TIMER ON OFF
Start
Stop
On
Set
2 hours later
after setting
10 hours later
after setting
h
h
Stop
On
Set 10 hours later
TIMER OFF
h
TIMER ON OFF
Start
Stop
Off
Set
2 hours later
after setting
5 hours later
after setting