To Next PageTo Next PageWhat to do if my Electrolux Kettle does not switch off?
If your Electrolux Kettle doesn't switch off automatically, ensure that you close the lid until it locks. Also, make sure that you insert the strainer correctly.
Why does my Electrolux Kettle switch off before boiling?
If your Electrolux Kettle switches off before the water boils, it might be due to too much lime scale at the base. Run the decalcifying procedure to resolve this.
Miksi Electrolux-keittimeni sammuu ennen kuin vesi kiehuu?
Jos Electrolux-keittimesi sammuu ennen kuin vesi kiehuu, se voi johtua liiallisesta kalkkikertymästä pohjassa. Tee kalkinpoisto tämän ratkaisemiseksi.
How to fix an Electrolux Kettle that cannot be switched on?
If your Electrolux Kettle cannot be switched on, it may be because it hasn't cooled down sufficiently after operating with little or no water. Allow it to cool for a short time, and then try again.
General| Type | Toaster |
|---|---|
| Removable crumb tray | Yes |
| Number of slices | 2 |
| Browning control | Yes |
| Cancel function | Yes |
| Extra lift function | Yes |
| Defrost function | Yes |
| Reheat function | Yes |
| Weight | 2.2 kg |
| Features | Removable crumb tray, Browning control, Cancel function, Extra lift function, Defrost function, Reheat function |
Get usage advice, brochures, troubleshooting, and service information via www.electrolux.com.
Register your product for better service at www.electrolux.com/productregistration.
Purchase accessories and consumables from www.electrolux.com/shop.
Perform initial rinse, set up base unit, and fill kettle with water to the desired level.
Use controls for boiling, temperature selection, keep warm functions, and auto switch-off.
Always unplug, wipe exterior with damp cloth, rinse kettle periodically.
Remove mesh filter, rinse under running water, and reinsert correctly.
Descale every three months with water and decalcifier. Do not boil the solution.
Possible cause: excessive lime scale. Solution: Perform descaling procedure.
Possible cause: lid not closed properly. Solution: Close lid until it locks.
Possible cause: strainer not inserted correctly. Solution: Insert strainer correctly.
Place packaging in appropriate containers for recycling.
Do not discard marked appliances with household waste. Return to local recycling facility.
