IMPORTANT SAFETY UPDATE
Room Air Conditioners manufactured after August 1
st
, 2004 are equipped
with a new industry regulated power cord with either of the following in
the plug-head or in line:
LCDI: Leakage Current Detection Interrupter
AFCI: Arc-Fault Circuit Interrupter.
All Frigidaire products have an LCDI located in the plug head or in-line.
The power supply cord contains a current device that senses damage to
the power cord. To test your power supply cord does the following:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO buttons on the plug head. Press the TEST
button. You will notice a click as the RESET button pops out.
3. Press the RESET button. Again you will notice a click as the button engages.
4. The power supply cord is now supplying electricity to the unit. (On some products
this is also indicated by a light on the plug head).
Notes:
● Do not use this device to turn the unit on or off.
● Always make sure the RESET button is pushed in for correct operation.
● The power supply cord must be replaced if it fails to reset when either the TEST
button is pushed, or it cannot be reset. A new one can be obtained from the
product manufacturer.
● If power supply cord is damaged, it CANNOT be repaired, it MUST be replaced by
one obtained from the product manufacturer.
3
To Next Page
Loading...
