14 OPERATING INSTRUCTIONS
Fault Codes
Removing Collected Water
1. If the display reads "AS" or "ES" , a sensor
has failed. Contact your Authorized
Frigidaire® Service Center.
2. If the display reads "EC" , check the
following operating conditions. Outlet
voltage should be 115V±10% and the
surrounding temperature should be with in
the range of 41 °F to 89 °F. Unplug the unit
and plug it in again under normal operating
conditions. If the "EC" code persists,
contact your Authorized Frigidaire®
Service Center.
3. If the display reads “E4”, the
communication between display PCB and
main control PCB is faulty. Contact your
Authorized Frigidaire® Service Center.
1. Emptying the Bucket:
a. When the bucket is full, the unit will shut
down and the BUCKET FULL indicator will
illuminate.
b. Do not move the unit at this time otherwise
water may spill on the floor.
c. Press sides of bucket gently to unclip the
bucket from the unit.
d. Remove the bucket as shown in the
photographs below and empty the bucket.
To Next Page
Loading...
