Touch pad once .
Touch START pad.
OFF
Touch and hold pad .
3
SETTING THE CLOCK ON/OFF
Clock display ON default.
2. Enter time using number
pads.
2. Time will display, after 3s, OFF
will display.
Touch TIMER pad once.
2. Enter desired time using
number pads.
1. Before operating your new oven make sure you
read and understand this Use and Care Guide
completely.
2. Before the Built-in Convention Microwave Oven
can be used, follow these procedures:
3
. Set clock. See below.
SETTING THE CLOCK
Example: setting clock display for 9:00:
3. Touch TIMER pad.
SETTING THE TIMER
Example: setting timer for 5 minutes:
NOTE
When the clock display off:
Press the button to enter the clock query
state and return to the standby mode after 1
second. The clock is not displayed.
Hold down the key for 1-3 seconds to display
the current clock. After 1 second, display the
current clock and enter the clock setting mode.
USING THE +10 SEC /+ 30 SEC KEY
This feature will let you quickly start or add 10 or
30 seconds
Touch the +10 SEC/+30 SEC pad to:
/
Press +30SEC pad twice.
1. Start programmed cooking.
2. Start cooking for 10 seconds/30 seconds at 100%
power level.
3. Extend cooking time in multiples of 10
seconds/30 seconds each time this pad is
touched during microwave cooking.
Example: to add 1 minute of cook time during
100% microwave cooking :
Example: to set the control lock ON:
Timer count down does not stop even if the door is
opened. To stop/cancel the timer, press the TIMER
key once . When the timer has reached the end of
set time, you will hear beep alerts indicating the
timer has run out.
CONTROL LOCK
You may lock the control panel to prevent the
microwave from being accidentally started or used
by children.
The control lock feature is very useful when cleaning
the control panel. The lock will prevent accidental
programming when wiping the control panel clean.
Touch and hold the CANCEL pad for
more than 3 seconds. The Lock icon
will appear in the display window
along with 1 beep.
• Plug in the oven. Close the door. The oven
display will flash 12:00.
• If no operation after 1 minute, the oven will show
12:01.
Example: to change the control lock from ON to
OFF:
Touch and hold the CANCEL pad for
more than 3 seconds. The Lock icon
will disappear in the display window.
10
OPERATION
To Next Page
Loading...
