Problem Possible cause Solution
The room temperature is
too high.
Refer to the climate class
chart on the rating plate or
to the "Positioning" sec‐
tion.
Food placed in the appli‐
ance was too warm.
Allow food to cool to room
temperature before stor‐
ing.
The lid is not closed prop‐
erly.
Check if the lid closes
properly and the gaskets
are not damaged or dirty.
The SUPER function is
switched on.
Refer to the "SUPER func‐
tion" section.
There is too much frost
and ice.
The lid is not closed prop‐
erly or the gasket is de‐
formed or dirty.
Check if the lid closes
properly. Clean the gasket
or replace it in case of any
damage.
Temperature is set incor‐
rectly.
Refer to the "Temperature
regulation" section.
The compressor does not
start immediately after
pressing the SUPER, or af‐
ter changing the tempera‐
ture.
This is normal, no error
has occurred.
The compressor starts af‐
ter a period of time.
The temperature in the ap‐
pliance is too low or too
high.
The temperature regulator
is not set correctly.
Set a higher or lower tem‐
perature.
The lid is not closed prop‐
erly.
Check if the lid closes
properly and the gaskets
are not damaged or dirty.
The products' temperature
is too high.
Allow food to cool to room
temperature before stor‐
ing.
Many products are stored
at the same time.
Store less products at the
same time.
The thickness of the frost
on the inner liner is greater
than 4-5 mm.
Defrost the appliance. Re‐
fer to the "Defrosting of the
freezer" section.
The lid was opened too of‐
ten.
Open the lid only if neces‐
sary.
The SUPER function is
switched on.
Refer to the "SUPER func‐
tion" section.
ENGLISH 75
To Next Page
Loading...
