7
Installing Door Handle
Door Handle Mounting
Instructions
1. Remove handles from carton and any other
protective packaging.
2. Position fresh food handle end caps over upper
and lower preinstalled shoulder bolts (A) that are
fastened into door.
3. While holding handle fi rmly against door, fasten
upper and lower Allen set screws (B) with supplied
Allen wrench until there is no gap between handle
and door.
Toe Grille Removal
To remove the toe grille, use a Phillips head
screwdriver and remove the two screws holding the
toe grille to the cabinet. Then pull the toe grille away
from the unit.
Leveling
• The refrigerator must have all bottom corners
resting fi rmly on a solid fl oor.
• The fl oor must be strong enough to support a fully
loaded refrigerator.
• It is VERY IMPORTANT for your refrigerator
to be level in order to function properly. If the
refrigerator is not leveled during installation,
the door may be misaligned and not close or
seal properly, causing cooling, frost or moisture
problems.
Leveling instructions continued on next page.
AA
B
C
AA
B
C
All set screws should be tightened so the screw is
below the surface of the handle. The handles should
be drawn tight to freezer and refrigerator doors with
no gaps. Opening the opposite door while tightening
the Allen screw makes installation easier.
The door handle may loosen over time or if it was
installed improperly. If this happens, tighten the set
screws on the handles.
Remove
Screws
Toe Grille
To Next Page
Loading...
