Electrolux KEAF7100L User Manual

Water softener
level
Amount of water
(l)
1 250
2 100
3 62
4 47
5 25
6 17
7 10
8 5
9 3
10 3
In case of the high water softener setting,
it may occur also in the middle of the
programme, before the rinse (twice
during a programme). Regeneration
initiation has no impact on the cycle
duration, unless it occurs in the middle of
a programme or at the end of a
programme with a short drying phase. In
that cases, the regeneration prolongs the
total duration of a programme by
additional 5 minutes.
Subsequently, the rinsing of the water
softener that lasts 5 minutes may begin
in the same cycle or at the beginning of
the next programme. This activity
increases the total water consumption of
a programme by additional 4 litres and
the total energy consumption of a
programme by additional 2 Wh. The
rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible
more than one in the same cycle) may
prolong the programme duration by
another 5 minutes when it occurs at any
point at the beginning or in the middle of
a programme.
All the consumption values
mentioned in this section are
determined in accordance
with the currently applicable
standard in laboratory
conditions with water
hardness 2.5mmol/L
according to the 2019/2022
regulation (water softener:
level 3).
The pressure and the
temperature of water as well
as the variations of the
mains supply can change
the values.
How to set the water softener
level
Make sure the appliance is in user mode.
1. Wait until the indicators and
are off and the indicator flashes.
The indicator still flashes.
The intermittent flashing of the
indicator shows the current
setting.
• e.g. 5 flashes + pause + 5 flashes
= level 5.
2. Press the programme button
repeatedly to change the setting.
Each pressing of the programme
button increases the level number.
After reaching level 10, the count
starts again from level 1.
3. Press on/off to confirm the setting.
6.3 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to
activate it.
www.electrolux.com10

Electrolux KEAF7100L Specifications

General

Cycle time	227 min
Noise level	49 dB
Drying system	AirDry
Delayed start timer	Yes
Dishwashing programs	Eco 50°C, Intensive 70°C, Normal, Quick, Soak
Number of place settings	13 place settings
Door color	Not applicable
Water fill	Cold, Hot
Control type	Buttons
Display type	LED
Product size	Full size (60 cm)
Appliance placement	Fully built-in
Control panel color	Silver
Wi-Fi controlled	No
Remaining time indication	-
Connected load	1950 W
Energy efficiency scale	A to G
Power consumption (off)	0.5 W
Water consumption per cycle	9.9 L
Energy consumption per cycle	1.036 kWh

Weight and Dimensions

Depth	550 mm
Width	596 mm
Height	720 mm
Depth with door open	1200 mm
Installation compartment width	600 mm
Installation compartment height (max)	880 mm
Installation compartment height (min)	820 mm