5.4 Replacing the lamp
This appliance is supplied with a LED
lamp. This part can be replaced by a
technician only. In case of any
malfunction refer to "Service" in the
"Safety Instructions" chapter.
6. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
6.1 What to do if...
Problem Possible cause Remedy
You cannot activate the
appliance.
The appliance is not con‐
nected to a power supply
or it is connected incorrect‐
ly.
Check if the appliance is
correctly connected to the
electrical supply.
You cannot activate the
appliance.
The fuse is blown. Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
You cannot open the slider
and the panel blinks red
and white.
The glass inside the appli‐
ance is opened.
Close the glass. Refer to
"Closing the glass" in the
"Before first use" chapter.
The lamp does not oper‐
ate.
The lamp is defective. Replace the lamp. Refer to
the "Care and Cleaning"
chapter.
The appliance does not
absorb enough vapours.
The motor speed is not ad‐
equate to the appearing
vapours.
Change the speed of the
motor.
The filter alarm indicator
is on.
The filter alarm is on. The
grease filter must be
cleaned or the charcoal fil‐
ter must be replaced or
cleaned.
Refer to the filter notifica‐
tion in "Daily use" chapter.
7. ENVIRONMENTAL CONCERNS
Recycle materials with the symbol .
Put the packaging in relevant containers
to recycle it. Help protect the
environment and human health by
recycling waste of electrical and
electronic appliances. Do not dispose of
appliances marked with the symbol
with the household waste. Return the
product to your local recycling facility or
contact your municipal office.
*
ENGLISH 7
To Next Page
Loading...
