What to do if water flows on the floor from my Electrolux Refrigerator?
If you find water on the floor near your Electrolux Refrigerator, the melting water outlet might not be correctly connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray.
What to do if the temperature in the Electrolux LNT6ME18S Refrigerator is too low or too high?
If the temperature in your Electrolux Refrigerator is not optimal, adjust the temperature setting to a higher or lower level as needed.
How to fix the temperature if it cannot be set on my Electrolux LNT6ME18S Refrigerator?
If you're unable to set the temperature on your Electrolux Refrigerator, the 'Extra Freeze' function might be active. You should switch off the 'Extra Freeze' function manually, or wait until the function deactivates automatically to set the temperature.
What to do if the lamp does not work in Electrolux LNT6ME18S Refrigerator?
If the lamp in your Electrolux Refrigerator isn't working, it might be in stand-by mode. Try closing and then opening the door to see if that activates the lamp.
What to do if my Electrolux LNT6ME18S does not operate?
If your Electrolux Refrigerator isn't working, the first thing to check is whether the appliance is switched off. If it is, simply switch it on.
Why is my Electrolux LNT6ME18S so noisy?
If your Electrolux Refrigerator is making excessive noise, it might not be properly supported. Check to ensure the appliance stands stable.
What to do if the Electrolux LNT6ME18S Refrigerator compressor operates continually?
Several factors can cause the compressor in your Electrolux Refrigerator to run constantly. Here are a few things to check: * Ensure the door is fully closed. * Avoid placing warm food in the refrigerator; let it cool first. * If many food products were put in at the same time, wait a few hours and then check the temperature again. * Check if the door is misaligned or interferes with the ventilation grill. Also, verify that the 'Extra Freeze' function is not activated and that the temperature setting is correct. If the room temperature is too high or the appliance isn't level, consult the installation instructions.
Why is there too much frost and ice in my Electrolux Refrigerator?
Excessive frost and ice in your Electrolux Refrigerator can be due to several reasons: * Ensure food products are properly wrapped. * Check that the door is closing correctly. * Make sure the gasket is clean and not deformed. Also, the temperature may be set incorrectly, or the appliance might be fully loaded at the lowest temperature setting. In this case, set a higher temperature.
Why won't the door of my Electrolux LNT6ME18S open easily?
If you're having trouble opening the door of your Electrolux Refrigerator immediately after closing it, wait a few seconds before trying again.
Why is the mains plug not connected to the mains socket correctly in Electrolux LNT6ME18S?
Connect the mains plug to the mains socket correctly.
General| Category | Refrigerator |
|---|---|
| Installation | Freestanding |
| Defrost Type | Frost Free |
| Energy Star Certified | No |
| Color | Stainless Steel |
| Energy efficiency class | E |
| Noise level | 42 dB |
| Climate class | SN-N-ST-T |
| Control type | Electronic |
| Display | Yes |
| Lighting | LED |
| Fridge net capacity | 13.3 cu ft |
| Freezer net capacity | 4.8 cu ft |
| Width | 595 mm |
To Next Page