Pull out the drawer again
and check if it is placed
correctly on both rear and
front hooks.
5.5 Humidity control
The glass shelf incorporates a device
with slits (adjustable by means of a
sliding lever), which makes it possible to
regulate the humidity in the vegetable
drawer(s).
The position of the humidity control
depends on the type and on the amount
of fruits and vegetables:
• Slots closed: recommended when
there is a small amount of fruits and
vegetables. In this way, the natural
moisture content in fruits and
vegetables is preserved longer.
• Slots opened: recommended when
there is a big amount of fruits and
vegetables. In this way, more air
circulation results in a lower air
moisture.
5.6 DYNAMICAIR
The refrigerator compartment is
equipped with a device that allows rapid
cooling of foods and keeps more uniform
temperature in the compartment.
This device activates automatically when
needed.
It is also possible to switch on the device
manually when needed (refer to
"DYNAMICAIR function").
The fan operates only when
the door is closed.
5.7 CleanAir filter
Your appliance is equipped with the
CleanAir carbon filter in a drawer inside
the DYNAMICAIR device.
The filter purifies the air from unwanted
odours in the fridge compartment,
improving the storage quality.
On delivery the filter is in a plastic bag
(Refer to "Care and cleaning" chapter for
the installation).
CAUTION!
During the operation, always
keep the air ventilation
drawer closed.
6. HINTS AND TIPS
6.1 Hints for energy saving
• Most efficient use of energy is
ensured in the configuration with the
drawers in the bottom part of the
appliance and shelves evenly
distributed. Position of the door bins
does not affect energy consumption.
• Do not open the door frequently or
leave it open longer than necessary.
• Do not set too high temperature to
save energy unless it is required by
the characteristics of the food.
• If the ambient temperature is high and
the temperature control is set to low
temperature and the appliance is fully
loaded, the compressor may run
continuously, causing frost or ice
formation on the evaporator. In this
case, set the temperature control
ENGLISH 13
To Next Page
Loading...
