Problem Possible cause Solution
The door is not closed
correctly.
Refer to "Closing the door".
The COOLMATIC func‐
tion is switched on.
Refer to "COOLMATIC func‐
tion".
There is too much frost
and ice.
The door is not closed
correctly or the gasket is
deformed/dirty.
Refer to "Closing the door".
The compressor does not
start immediately after
pressing the COOLMATIC,
or after changing the tem‐
perature.
This is normal, no error
has occurred.
The compressor starts after
a period of time.
Water flows inside the re‐
frigerator.
The water outlet is clog‐
ged.
Clean the water outlet.
Food products prevent
that water flows into the
water collector.
Make sure that food prod‐
ucts do not touch the rear
plate.
Water flows on the floor. The melting water outlet
is not connected to the
evaporative tray above
the compressor.
Attach the melting water out‐
let to the evaporative tray.
Temperature cannot be
set.
The COOLMATIC func‐
tion is switched on.
Switch off COOLMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to " COOLMATIC function".
DEMO appears on the dis‐
play.
The appliance is in dem‐
onstration mode.
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Door is misaligned or inter‐
feres with ventilation grill.
The appliance is not lev‐
elled.
Refer to "Levelling".
The temperature in the ap‐
pliance is too low/too high.
The temperature regula‐
tor is not set correctly.
Set a higher/lower tempera‐
ture.
The door is not closed
correctly.
Refer to "Closing the door".
Food products placed in
the appliance were too
warm.
Allow food products to cool
to room temperature before
storing.
ENGLISH 13
To Next Page
Loading...
